How To Make A Pallet Christmas Tree | DIY
You’ll Need:
- Pallet
- Circular Saw
- Drill w/ a drill bit & screw bit
- Hammer
- Exterior Wood Screws
- Interior Wood Screws
- Newspaper
- Green Paint
- Paint Brush
- Tacks
- Christmas Lights
- Red Bow
Directions: (video below)
- Draw a triangle on your pallet. Start at the top and in the middle and then go to the bottom corners.
- Cut along the lines with your circular saw. Also, cut the back.
- Set aside the side pieces.
- Screw 2 screws into each board on your Christmas tree
- Strip off all the wood from the end pieces you set aside. You only need the center post.
- Cute the center post into 4 9″ pieces sections
- Hammer in 2 of the 9″ pieces of wood into the bottom of the tree. Then screw in 2 screws into each side to hold it in place
- Screw in the last two pieces into the bottom of your tree
- Paint your tree green
- Add lights and your bow. Then you’re done!
